
use Hess’s law and standard enthalpies of formation to find ΔH for the candidate heating reactions, set a zero reference for chemical potential energy, and compare the candidates by energy per gram.
Phase 3: Make Sense
Do Now. You can climb from the gym floor to the third floor by the stairs or by the elevator. Does the route change how much higher you end up? Write one sentence, then guess what this has to do with reactions.
Iron can rust to Fe2O3 in one step, or first form FeO and then Fe2O3. How do the total energy changes compare?
Not every reaction fits in a coffee cup. Iron rusts over hours; magnesium makes hydrogen gas. We need ΔH values we cannot easily measure, and we can get them by adding up reactions whose values are known.
Hess’s law. ΔH is a state function: like your height above the gym floor, it depends only on where you start and finish. So if a reaction can be written as the sum of steps, its ΔH is the sum of the steps’ ΔH values. Two rules: reversing a reaction flips the sign of ΔH; multiplying a reaction by a number multiplies ΔH by the same number.
Worked example 1: rusting in two steps. Nadia used two steps. Step 1: 2Fe(s) + O2(g) → 2FeO(s), ΔH = 2(−272.0) = −544.0 kJ. Step 2: 2FeO(s) + ½O2(g) → Fe2O3(s), ΔH = −280.2 kJ. Adding them, the 2FeO cancels: 2Fe(s) + 1½O2(g) → Fe2O3(s), ΔH = −824.2 kJ, exactly the published enthalpy of formation of Fe2O3. Doubled for the hand warmer equation, 4Fe + 3O2 → 2Fe2O3 has ΔH = −1,648.4 kJ.
A zero reference for chemical energy. Potential energy is always measured from a chosen zero, like height measured from the gym floor. Chemists choose the elements in their standard states (Fe(s), O2(g), Mg(s), H2(g)) as zero. The standard enthalpy of formation, ΔHf°, of a compound is its energy relative to that zero: H2O(l) −285.8, MgO(s) −601.6, Mg(OH)2(s) −924.5, Fe2O3(s) −824.2 kJ/mol. Then ΔH = ΣΔHf°(products) − ΣΔHf°(reactants), which is Hess’s law in a single line.
Worked example 2: the magnesium heater. Rafael found ΔH for Mg(s) + 2H2O(l) → Mg(OH)2(s) + H2(g). Products: −924.5 + 0 = −924.5 kJ. Reactants: 0 + 2(−285.8) = −571.6 kJ. ΔH = −924.5 − (−571.6) = −352.9 kJ per mole of Mg. He checked it by Hess’s law through three steps (Mg + ½O2 → MgO, −601.6; MgO + H2O → Mg(OH)2, −37.1; H2O → H2 + ½O2, +285.8) and got the same −352.9 kJ.
Energy per gram: the number the client needs. A shipping pallet is limited by mass, so divide by molar mass.
| Candidate | ΔH | Energy per gram of active chemical | Speed and notes |
|---|---|---|---|
| Iron oxidation (to Fe2O3) | −412.1 kJ/mol Fe | 7.38 kJ/g Fe | Slow, hours; needs air, salt and water |
| Magnesium + water | −352.9 kJ/mol Mg | 14.5 kJ/g Mg | Fast with salt water and iron, minutes; makes H2 gas |
| CaCl2 dissolving | −81.3 kJ/mol | 0.733 kJ/g | Fast, seconds; needs a lot of salt |
| MgSO4 (anhydrous) dissolving | −91.2 kJ/mol | 0.758 kJ/g | Fast; needs a lot of salt |
| Sodium acetate trihydrate crystallizing | about 0.26–0.29 kJ/g (published latent heats vary) | about 0.27 kJ/g | Holds near 54 °C; reset by heating in boiling water |
Reading. OpenStax Chemistry 2e, chapter 5.3 (Hess’s law and standard enthalpies of formation) and Appendix G (standard thermodynamic properties), CC BY 4.0; enthalpies of solution from the NIST/NBS tables of chemical thermodynamic properties.
Use the ΔHf° values from the lecture and molar masses Fe 55.85, Mg 24.31, CaCl2 110.98 g/mol.
Candidate comparison, in your Energy Notebook.
For the meal pouch (41.8 kJ needed, ignoring losses), calculate the mass of each candidate required. Rank them by mass, then explain why mass alone does not decide the choice.
Explain, using bonds broken and formed and the zero reference, why Mg(OH)2 + H2 sits 352.9 kJ lower in potential energy than Mg + 2H2O, and where that energy goes in the meal pouch.
We know how much energy each candidate can release. Next phase we build a model that predicts what that energy does to a real meal.
Exit ticket: which candidate would you choose for the meal pouch and which for the reusable hand warmer, based only on today's table? Name the one fact that drove each choice.
Materials: printed ΔHf° table (from OpenStax Appendix G), equation strips students can flip and scale for Hess’s law, calculators.
Notes on values: real hand warmers make hydrated iron oxides and iron oxide-hydroxide rather than pure Fe2O3; the Fe2O3 value is a model simplification of the same size. The sodium acetate value is a latent heat from the thermal-storage literature and is given as a range.
Listen for: sign not flipped on a reversed step; coefficients not applied to ΔH; “elements have no energy” (they have energy; we just call it zero).
Support / stretch: provide a step template (write, flip, scale, cancel, add). Stretch: use ΔHf° of CaCl2(s) and the aqueous ions to check the −81.3 kJ/mol enthalpy of solution.