change one part of the latch based on evidence, retest it and tell whether it improved.
Phase 4: Build
Do Now. Read your failure point from last time. What one change could fix it? Say it to a partner in one sentence.
A door opens with 28 washers, which is too hard. What will happen if we add a cardboard spacer between the magnet and washer?
The reading opens over the lesson; close it to come back to exactly where you were.
Version 2 begins with evidence. Look at your failure point. Choose the change most likely to fix it. Change just one main thing, so you can tell what caused the new result.
Distance is a tool. A cardboard spacer makes a gap. A bigger gap makes the magnetic pull weaker. Taking a spacer away makes the pull stronger.
Direction matters, too. If two magnets face each other, turning one around can change a pull into a push.
Worked example 1: Layla adds spacers (sample data). With no spacer, her Pull Score is 28. One layer gives 19. Two layers give 12. Three layers give 8. She sees a pattern: more layers, smaller score. She picks two layers, right in the middle of the sweet spot.
Worked example 2: Sam fixes Click Back (sample data). Sam’s door clicked 6 of 10 times. He moved the washer to line up with the magnet. He changed nothing else. Now it clicks 9 of 10 times. His change worked, and his data proves it.
Retest everything important. A fix can cause a new problem. After you change the gap, check Pull, Bump and Click Back again.
Plan your change, make it and retest.
Tell the story of Version 2.
What did you change? Why did your evidence point to that change?
Give your before and after data. Did the change help? Did it cause any new problem?
You used evidence to make your design better. Next comes the Final Test.
Exit ticket: Write one question about magnets you could still test.
How confident are you that you can I can explain how distance changes magnetic force.
Pacing: Do Now 5, instruction 8, revise and retest 17, independent 6, closure 4.
Materials: prototypes, cardboard spacers, tape, washers, data tables with Version 1 and Version 2 columns.
Misconceptions: changing many things is faster; a fix can only help; stronger magnetic pull is always the goal.
Supports: offer a menu of changes matched to failure points. Stretch: graph Pull Score against number of spacers.
Answer guide: students connect the change to evidence, show before and after data and tell whether the criterion is now met. For 4 spacers, any prediction below 8 that cites the pattern is correct.
NASA Glenn Research Center, Wright 1901 Wind Tunnel Tests · U.S. government work, public domain
Before they built their famous airplane, Wilbur and Orville Wright built gliders. Their 1900 and 1901 gliders did not do as well as they predicted. The 1901 glider made only about one-third of the lift they expected. Lift is the upward force on a wing.
The brothers did not give up. They first put small wing shapes on a bicycle wheel and rode around to make moving air. But that test was hard to control. So they built a wind tunnel, a box where a fan moves air past a model.
From September to December 1901, they tested small metal wings. They made between 100 and 200 models in their bicycle shop. Then they studied about 30 of the best designs. Between models, they changed only one thing at a time.
Their careful data helped them design the 1902 glider. It fixed the problems of the earlier gliders.
You can work the same way. Change one thing. Test again. Let the results guide you.
Source: NASA Glenn Research Center, Wright 1901 Wind Tunnel Tests (grc.nasa.gov)