observe a swinging weight, describe the pattern in its motion, and decide what data will show that pattern.
Phase 2: Investigate
Do Now. Think about a child on a playground swing. Move your finger in the air to show the path. Forward, back, forward, back. Then talk with a partner: what would come next?
A swing has just moved forward. What will it do next?
The reading opens over the lesson; close it to come back to exactly where you were.
Patterns in motion. A pattern is something that repeats in a way we can notice. A swing goes back and forth. A seesaw goes up and down. A marble rolls from side to side in a bowl.
Why look for patterns? If we know a motion’s pattern, we can predict what it will do next. Predicting helps people plan and build.
What force is at work? Gravity pulls the weight down. The string keeps it from falling. So the weight swings back toward the middle, again and again.
What should we count? One full swing means over and back to where it started. We will count full swings for 20 seconds. We will do that three times with the same string.
Worked example 1: describing the pattern. Noor watches a washer on a string. She writes: “It goes left, then right, then left again. It keeps repeating.” She describes the motion in order.
Worked example 2: sample count. Here is sample data from Eli’s team, with a 25 cm string. Trial 1: 20 full swings. Trial 2: 19. Trial 3: 20. Eli says, “The count stays about the same. That is a pattern.”
Lab. Tie a washer to a 25 cm string. Tape the string to a table edge. Pull the washer a little to one side and let go. Do not push it. Count full swings for 20 seconds. Run 3 trials.
Show the motion.
Draw the washer's path with arrows. Write what we counted and why those numbers help us see a pattern.
Some motion repeats. Next time we will use our pattern to make predictions, then test them.
Exit ticket: why is it useful to find a pattern in the way something moves?
Pacing (40 min): Do Now 4, reading 5, mini lecture 7, lab 15, independent work and exit ticket 9.
Materials per team: string, 1 washer, tape, ruler, timer. Use the teacher as the timekeeper if timers are limited.
Boundary: do not introduce the terms period or frequency. Students simply count full swings and describe patterns.
Misconceptions: students may push the washer or count each pass as a full swing. Model the count together first. Expect counts near 20 for a 25 cm string; differences of 1 or 2 are normal. The worked example uses sample data.
Supports: one partner says “over, back, one” aloud. Stretch: does a small or a slightly bigger starting pull change the count much?
Answer guide: a pattern means counts stay close and the path repeats. Usefulness: it lets us predict and plan.
National Institute of Standards and Technology, A Walk Through Time: A Revolution in Timekeeping · U.S. government work, not subject to U.S. copyright
A pendulum is a weight that swings back and forth on a string or rod. Long ago, people found a very useful thing about it. Its swing repeats again and again in a steady way.
A scientist named Galileo Galilei studied how pendulums move. He began as early as 1582. He even drew a plan for a pendulum clock. But he died in 1642 and never built one.
In 1656, a Dutch scientist named Christiaan Huygens made the first pendulum clock. It was off by less than one minute a day. That was very good for its time. Later he improved it, and it was off by less than 10 seconds a day.
Clockmakers kept making these clocks better for hundreds of years.
Why did this work? A clock needs something that keeps a steady beat. A swing that repeats can do that job. When people find a pattern in motion, they can put it to use.
Source: National Institute of Standards and Technology, A Walk Through Time: A Revolution in Timekeeping (nist.gov)