
use the particle model to explain temperature, effusion and the cooling of an expanding gas, account for energy as particle motion and relative position, and show that energy is conserved across a system and its surroundings.
Phase 3: Make Sense
Do Now. A helium party balloon sags by the next morning; an air-filled balloon from the same bag still looks fine. Look back at your 1.01 model and write one thing you would add to explain the difference.
At the same temperature, helium atoms and nitrogen molecules have the same average kinetic energy.
Same energy, different speeds. The average kinetic energy of a gas particle is KEavg = (3/2)kBT, where the Boltzmann constant kB = 1.381 × 10−23 J/K. It depends only on kelvin temperature, not on the kind of particle. Since KE = ½mv2, lighter particles move faster at the same temperature. At 288 K a typical helium atom moves about 1,340 m/s and a nitrogen molecule about 506 m/s.
Worked example 1: kinetic energy on the way up. Ibrahim compared a helium atom at launch (288 K) with one at 20 km (217 K). KEavg = 1.5 × 1.381 × 10−23 × 288 = 5.97 × 10−21 J at launch, and 4.50 × 10−21 J at 20 km. Ratio 217/288 = 0.75: each particle carries, on average, a quarter less energy. Multiply by the number of particles and the “temperature” of the gas you can see is the total motion of particles you cannot.
Graham’s law, qualitatively. Effusion is gas escaping through tiny holes; diffusion is gases spreading through each other. Both are faster for lighter particles. Graham’s law: the rate is inversely proportional to the square root of molar mass. Helium (4.0 g/mol) effuses about √(29.0 / 4.0) ≈ 2.7 times faster than air (average 29.0 g/mol). Latex is full of microscopic gaps, so a helium balloon loses its gas much faster than an air balloon. For the station, this means: fill the balloon on launch day, not the night before.
Where does the cold come from? Energy conservation. When a gas expands against its surroundings it pushes them back: it does work. If no energy flows in from outside, that work comes out of the particles’ own kinetic energy, so the gas cools. Particle picture: particles bouncing off a wall that is moving away come back slower, like a ball bounced off a retreating paddle. Rising air on a dry day cools by about 9.8 °C per kilometer for exactly this reason; the helium in the balloon cools the same way as it expands. In the gas + surroundings system, the total energy is the same before and after: the gas’s loss equals the work done on the air around it.
Energy in relative positions. In a gas the particles are far apart and barely attract, so nearly all its thermal energy is kinetic. In liquids and solids, particles are close and attract strongly, so their thermal energy also includes potential energy from their positions, and particles in a solid vibrate in place. When particles move closer together and attraction pulls them into position, potential energy falls and that energy is released. Water vapor condensing into cloud droplets releases about 44 kJ/mol at 25 °C; liquid water freezing releases 6.01 kJ/mol (334 J/g).
Worked example 2: energy bookkeeping for a water pack. Chen proposed a pack of water beside the battery. Cooling 100 g of liquid water by 1 °C releases 100 g × 4.18 J/(g·°C) × 1 °C = 418 J. Freezing 50 g of water at 0 °C releases 50 g × 334 J/g = 16,700 J, as much as cooling 100 g of water by 40 °C, with no temperature drop while it freezes. The energy was stored in the positions of the water molecules, not in their speed.
The revised model. Our model of the flight now has three energy ideas: (1) temperature is average particle kinetic energy; (2) an expanding gas does work on its surroundings and cools, with total energy conserved; (3) energy can be stored in particle positions and released when particles move together, as in freezing or condensing. The battery problem is an energy-flow problem: the battery (system) loses energy to the slower-moving particles of the cold air that collide with its box, and insulation slows that transfer.
Reading. OpenStax Chemistry 2e, section 9.4 (effusion and diffusion), section 9.5 (kinetic-molecular theory), chapter 5 (energy, specific heat) and section 10.3 (phase transitions), CC BY 4.0.
Work in pairs. Every answer names particles and energy.
Return to the Wonder Board and the phenomenon.
Write a claim-evidence-reasoning paragraph that explains both the puffy chip bag and the freezer balloon with one particle model. Use evidence from 1.03 and 1.04 and the words kinetic energy, collision and kelvin.
Choose two Wonder Board questions we can now answer and answer each in 2–3 sentences. Name one question still open.
Our model now tracks energy as well as particles. Next phase, we design the flight plan and build the payload box.
Exit ticket: the air at 20 km is −56.5 °C. In two sentences, explain at the particle level how a warm battery loses energy to that air, and one way to slow it down.
Materials: the class model poster from 1.01, a helium party balloon and an air balloon filled the day before (teacher only; never inhale helium), the Wonder Board, sticky notes.
Demo option: put a few drops of vanilla extract in one balloon before blowing it up; students smell it outside the balloon within minutes, which makes diffusion through latex visible.
Listen for: “it is cold up high because there is less air to hold heat” (the bigger reason is expansion); “heavier particles have more energy”; “freezing takes energy in.”
Support / stretch: give an energy-bookkeeping table (system, surroundings, energy in, energy out). Stretch: estimate the rms speed of helium at 217 K from v = √(3RT/M) with M in kg/mol (about 1,160 m/s).