measure the rise and run of ramps, write slope as a ratio, and decide whether a ramp meets the 1:12 rule.
Phase 2: Investigate
Do Now. Look at the ramp at our school entrance (or a photo of one). Why might a ramp that is too steep be a problem? Write one idea.
A ramp must rise 2 feet. Which run makes it less steep?
The reading opens over the lesson; close it to come back to exactly where you were.
Ramps are slopes you can touch. A ramp’s rise is how high it climbs. Its run is how far it goes across, measured flat along the ground. Slope = rise ÷ run, the same as on a graph.
Ratios and percents. The ADA guide writes the steepest allowed ramp slope as 1:12. As a fraction that is 1/12, and as a decimal about 0.0833, or about 8.33 percent. A slope of 5 percent is 5/100 = 1/20, which is gentler.
Worked example 1: is this ramp allowed? Nadia measures a sample ramp. Its rise is 3 inches and its run is 30 inches. Step 1: slope = 3 ÷ 30 = 1/10. Step 2: compare 1/10 with 1/12. Write both with denominator 60: 6/60 and 5/60. Step 3: 6/60 > 5/60, so 1/10 is steeper than 1/12. Step 4: the ramp is too steep; it would need a longer run.
Worked example 2: how long must it be? Carlos needs a ramp that rises 2 feet (24 inches). Step 1: at 1:12, every 1 inch of rise needs 12 inches of run. Step 2: run = 24 × 12 = 288 inches. Step 3: 288 ÷ 12 = 24 feet. Step 4: check: 24 ÷ 288 = 1/12. A 24-inch rise is under the 30-inch limit, so one run is enough.
A ramp is a line. If you draw the ramp’s side on a grid with run on the x-axis and rise on the y-axis, the ramp’s surface is a line segment with slope 1/12. Every point on a 1:12 ramp has rise = run ÷ 12.
Investigation. Build ramps with a board and a stack of books. Measure rise and run with a ruler, compute each slope, and roll a toy car to feel the difference.
Use your ramp measurements and the reading’s rules.
Ramp lab record sheet.
Build three book ramps with different heights. For each, record rise, run and slope as a fraction and a decimal (round to the thousandth). Which ramps meet 1:12?
A ramp rises 1.5 feet. What is the shortest run that meets 1:12?
Draw one of your ramps on a grid with run on the x-axis and rise on the y-axis. Mark the slope.
Slope is rise over run, on ramps and on graphs. Next we prove that a straight line has the same slope everywhere.
Exit ticket: a ramp has rise 2 inches and run 20 inches. Is it allowed? Show the comparison with 1/12.
Pacing: Do Now 4 min, reading 7, mini lesson 9, ramp lab and guided practice 15, exit ticket 5.
Materials: boards or stiff folders, books, rulers or meter sticks, toy cars. Measure run flat along the floor, not along the board.
Accuracy: 1/2-inch change in level, 1:12 maximum (8.33%), 5% threshold, 1:48 cross slope, 30-inch rise per run, handrails above 6 inches and the gentler-slope recommendation are from the Access Board guide read 2026-11-20. All sample ramps are invented.
Likely misconceptions: measuring the board’s length instead of the flat run; thinking 1:12 is “12 times steeper”; comparing fractions by denominators only.
Supports: a fraction-to-decimal chart (1/8, 1/10, 1/12, 1/15, 1/20). Stretch: what percent is 1:48? (about 2.08%).
Answer guide: 36-inch rise: each run may rise at most 30 inches, so it needs at least two runs with a level landing between. Exit ticket: 2/20 = 1/10, which is steeper than 1/12 (6/60 vs 5/60), so it is not allowed.
U.S. Access Board, Guide to the ADA Accessibility Standards, Chapter 4: Ramps and Curb Ramps · U.S. government work, public domain
The U.S. Access Board is a federal agency that writes guides to the ADA Standards, the rules that make buildings usable for people with disabilities. Its guide to ramps explains how steep a ramp may be.
The guide says ramps are needed along accessible routes wherever the ground changes level by more than half an inch. It defines slope as the proportion of vertical rise to horizontal length, and writes it as a ratio, such as 1:12. Slope can also be written as a percent.
A ramp’s running slope can be no steeper than 1:12. That means 1 unit of rise for every 12 units of length, or about 8.33 percent. The slope should be the same along the whole run. Any part of a route steeper than 5 percent must be treated as a ramp. The side-to-side slope, called cross slope, can be no more than 1:48.
Each run of a ramp can rise no more than 30 inches, but a ramp may have many runs with level landings between them. Ramps that rise more than 6 inches need handrails on both sides. The guide recommends a gentler slope than the maximum when possible, because it is easier for more people to use.
Source: U.S. Access Board, Guide to the ADA Accessibility Standards, Chapter 4: Ramps and Curb Ramps (access-board.gov)