
solve absolute value equations and inequalities, graph their solution sets, and interpret them as distances and tolerances in context.
Instruction
The key to absolute value is to read it as distance. |x − a| is the distance on the number line between x and a. Every absolute value equation or inequality is then a question about distance, and the algebra follows from that picture.
Equations. |x − 3| = 5 asks which numbers are 5 units from 3: 8 and −2. Algebraically, |A| = c with c > 0 means A = c or A = −c. Solve |2x − 5| = 7: 2x − 5 = 7 gives x = 6, and 2x − 5 = −7 gives x = −1. Check both: |7| = 7 and |−7| = 7. If c = 0 there is one solution, and if c < 0 there are none: |x + 2| = −3 has no solution, because no distance is negative. Isolate the absolute value first: 3|x + 1| − 4 = 11 becomes |x + 1| = 5, so x = 4 or −6.
“Less than” inequalities are intervals. |x − 68| ≤ 4 describes numbers within 4 of 68: 64 ≤ x ≤ 72. In general |A| ≤ c is the compound inequality −c ≤ A ≤ c. On a number line, a closed segment from 64 to 72. In context, a thermostat set to 68°F with a 4-degree swing keeps the room in that interval.
“Greater than” inequalities are two rays. |3x + 1| > 8 means 3x + 1 is more than 8 away from 0: 3x + 1 > 8 or 3x + 1 < −8, so x > 7/3 or x < −3. The graph is two rays pointing away from each other, with open circles because the inequality is strict. Writing it as one compound “and” inequality, −8 > 3x + 1 > 8, is a common error: no number is both less than −8 and greater than 8.
Tolerance. Manufacturing specifications are absolute value inequalities. A bolt specified as 12.00 ± 0.05 mm is acceptable when |d − 12.00| ≤ 0.05, that is, 11.95 ≤ d ≤ 12.05. A quality inspector rejects a part when |d − 12.00| > 0.05. Creating these inequalities from a description (A2.REI.A.1) means naming the target, the allowed distance and whether the boundary is included.
Graphs (A2.REI.B.3). The solutions of |2x − 5| = 7 are the x-coordinates where the V-shaped graph of y = |2x − 5| meets the horizontal line y = 7. The solutions of |2x − 5| < 7 are the x-values where the V is below the line: −1 < x < 6. The graph makes the and/or distinction visible: below the line is one connected piece; above it, two.
Discourse task (MP.3). Your group will get four student solutions to |x − 4| ≥ 2x + 1, some correct and some not. Decide which are correct, and for each incorrect one write a critique that names the faulty step. Watch especially for cases where the right side can be negative, which is exactly where the distance reasoning must be applied with care. Then check the correct answer with a graph of both sides.
📖 Read for this lesson
The reading opens over the lesson; close it to come back to exactly where you were. The checks below draw on it.
Formative check
Work through these before moving on. They are not graded — they tell you whether the standard below has landed yet.
What is the solution set of |3x + 1| > 8?
A bolt specified as 12.00 ± 0.05 mm is acceptable when |d − | ≤ , that is, from to 12.05 mm.
The equation |x + 2| = −3 has two solutions, x = 1 and x = −5.
Solve |2x − 5| < 7 algebraically and by graphing y = |2x − 5| and y = 7. Graph the solution set on a number line. Then write a real tolerance situation of your own that this inequality could describe, with units.
How confident are you that you can solve and graph absolute value equations and inequalities and interpret them as distances?
Practice
Work these on paper or in your notebook, then open Check your answer. Aim for all of Fluency and Application; try at least one Challenge.
Printable version: this unit’s practice workbook (PDF)
Fluency
Build speed and accuracy with the core skill.
- Solve: |x − 7| = 3
Check your answer
Answer: x = 4 or x = 10x − 7 = 3 or x − 7 = −3. - Solve: |x − 3| = 1
Check your answer
Answer: x = 2 or x = 4x − 3 = 1 or x − 3 = −1. - Solve: |x + 3| = −9
Check your answer
Answer: No solutionAn absolute value is never negative. - Solve: |x + 6| = 9
Check your answer
Answer: x = −15 or x = 3x + 6 = 9 or x + 6 = −9. - Solve and graph: |x − 8| < 4
Check your answer
Answer: 4 < x < 12Distance from 8 is less than 4: −4 < x − 8 < 4. - Solve and graph: |x − 1| ≥ 2
Check your answer
Answer: x ≤ −1 or x ≥ 3Distance from 1 is at least 2: x − 1 ≤ −2 or x − 1 ≥ 2. - Solve and graph: |x − 6| ≥ 6
Check your answer
Answer: x ≤ 0 or x ≥ 12Distance from 6 is at least 6: x − 6 ≤ −6 or x − 6 ≥ 6. - Solve and graph: |x + 7| < 5
Check your answer
Answer: −12 < x < −2Distance from −7 is less than 5: −5 < x + 7 < 5. - Solve 3|x + 1| − 4 = 11.
Check your answer
Answer: x = 4 or x = −6 - Solve |3x + 1| > 8 and describe the graph.
Check your answer
Answer: x < −3 or x > 7/3; two rays with open circles
Application
Use the skill in context. Show your reasoning.
- A bolt must be 12.00 ± 0.05 mm. Write the acceptable lengths as an absolute value inequality and solve it.
Check your answer
Answer: |d − 12.00| ≤ 0.05; 11.95 ≤ d ≤ 12.05 - A Kansas City office thermostat keeps a room within 3°F of 70°F. Write and solve the inequality, and say what temperatures trigger the heater or air conditioner.
Check your answer
Answer: |T − 70| ≤ 3; 67 ≤ T ≤ 73; below 67 or above 73 - A cereal box should hold 510 g, and boxes more than 8 g away from that are rejected. Write the rejection condition and solve it.
Check your answer
Answer: |w − 510| > 8; w < 502 or w > 518
Challenge
Stretch problems. Expect to think before you write.
- Solve |x − 4| ≥ 2x + 1 and check with a graph.
Check your answer
Answer: x ≤ 1Case x ≥ 4: x − 4 ≥ 2x + 1 gives x ≤ −5, impossible. Case x < 4: 4 − x ≥ 2x + 1 gives x ≤ 1.
Review
Keep earlier skills sharp.
- Solve for x: 1.05x = 1000. Give an exact answer using logarithms and a decimal to the nearest thousandth.
Check your answer
Answer: x = log 1000 / log 1.05 ≈ 141.581Take the logarithm of both sides and use the power property. - Evaluate: log3 (1/3)
Check your answer
Answer: −1Ask: 3 to what power gives 1/3?
Four Solutions to Judge, and Three Real Tolerances to Write
Student work is SLS original, written for this lab; specifications from USPS Notice 123, effective July 12, 2026, retrieved September 23, 2026 · SLS original, with public-domain U.S. Postal Service specifications
Why this reading. The lesson says “your group will get four student solutions to |x − 4| ≥ 2x + 1, some correct and some not.” Here they are. They were written for this lab; no real student wrote them, and each was built around one specific mistake or one specific good idea. Your job is to decide which are correct and to name the faulty step in the others — not to say “this one is wrong,” but to point at the line where it goes wrong and say why.
The problem
Solve |x − 4| ≥ 2x + 1.
Solution A
“Greater-or-equal means two rays, so x − 4 ≥ 2x + 1 or x − 4 ≤ −(2x + 1).
First: −5 ≥ x, so x ≤ −5.
Second: x − 4 ≤ −2x − 1, so 3x ≤ 3, so x ≤ 1.
Answer: x ≤ −5 or x ≤ 1, which is x ≤ 1.”
Solution B
“The right side can be negative, so I split on its sign.
Case 1, 2x + 1 < 0, that is x < −1/2. An absolute value is never negative, so |x − 4| ≥ 2x + 1 is automatically true. Every x < −1/2 is a solution.
Case 2, 2x + 1 ≥ 0, that is x ≥ −1/2. Now both sides are non-negative and the two-ray rule applies: x − 4 ≥ 2x + 1 gives x ≤ −5, which is outside this case; x − 4 ≤ −2x − 1 gives x ≤ 1. Combined with x ≥ −1/2, that is −1/2 ≤ x ≤ 1.
Answer: x < −1/2 or −1/2 ≤ x ≤ 1, which is x ≤ 1.”
Solution C
“Square both sides to get rid of the absolute value.
(x − 4)2 ≥ (2x + 1)2
x2 − 8x + 16 ≥ 4x2 + 4x + 1
0 ≥ 3x2 + 12x − 15 = 3(x + 5)(x − 1)
So −5 ≤ x ≤ 1.
Answer: −5 ≤ x ≤ 1.”
Solution D
“|x − 4| is the distance from x to 4. I want the distance to be at least 2x + 1. I graphed y = |x − 4| and y = 2x + 1 and looked for where the V is on or above the line. The two graphs meet at x = 1 only, and the V is above the line everywhere to the left of that.
Answer: x ≤ 1.”
What to do with them
Work the problem yourself first. Then, for each solution, write one of two things: “Correct, and here is the step that makes it airtight” or “Wrong at line N, because…” — with a number that fails, wherever you can produce one. A counterexample beats an objection.
Three questions to steer you. (1) Two of these reach the same answer by reasoning of very different quality; does reaching the right answer make a method right? (2) Solution C’s squaring step assumes something about both sides; state what, and test its answer at x = −6, where 2x + 1 = −11. (3) Solution A never mentions the sign of the right side at all. Does that matter here, and would it matter for |x − 4| ≤ 2x + 1? Try that second inequality and see how differently it behaves.
Three tolerances from a real specification
The Postal Service publishes what a First-Class letter may measure. Each row is a permitted interval, and each can be written as an absolute value inequality by finding the midpoint and half the width.
| Dimension | Minimum | Maximum | Center | Half-width | Inequality |
|---|---|---|---|---|---|
| Length | 5 in | 11.5 in | 8.25 | 3.25 | |L − 8.25| ≤ 3.25 |
| Height | 3.5 in | 6.125 in | 4.8125 | 1.3125 | |H − 4.8125| ≤ 1.3125 |
| Thickness | 0.007 in | 0.25 in | 0.1285 | 0.1215 | |T − 0.1285| ≤ 0.1215 |
Test a standard No. 10 business envelope, 9.5 in by 4.125 in. Length: |9.5 − 8.25| = 1.25 ≤ 3.25 ✓. Height: |4.125 − 4.8125| = 0.6875 ≤ 1.3125 ✓. It passes, with room on both. Now test a square greeting-card envelope 6.5 in by 6.5 in: length |6.5 − 8.25| = 1.75 ≤ 3.25 ✓, height |6.5 − 4.8125| = 1.6875 > 1.3125 ✕. It fails on height by 0.375 inch, which is why square envelopes carry a surcharge.
A distinction worth arguing about in the lab. A machinist’s specification of 12.00 ± 0.05 mm has a target, and the absolute value form says exactly what the designer meant: get as close to 12.00 as you can. The postal specification has no target — nobody is trying to make an 8.25-inch envelope — and rewriting it as |L − 8.25| ≤ 3.25 is mathematically correct and rhetorically misleading. Same algebra, different meaning. Deciding which form to write is a modeling decision, not an algebraic one, and you should say in your write-up which of the three rows above you would leave as a plain double inequality and why.
Sources: USPS Notice 123, Price List (Postal Explorer) (pe.usps.com)