estimate before solving, check answers against the story, and decide how to round or interpret a solution so the build plan works.
Phase 3: Make Sense
Do Now (sample data). Deck boards for the shed floor are 5.5 inches wide. The floor is 64 inches across. A student solves 5.5b = 64 and gets b = 11.6.
How many boards should the crew buy?
The reading opens over the lesson; close it to come back to exactly where you were.
Solving is half the job. The other half is asking: does this answer make sense? A solution can be correct for the equation and still need rounding, a unit or a second look before it goes into the build plan.
Three questions to ask. (1) Is it about the size my estimate said? (2) Does it fit the story: whole numbers for boards and bags, no negative lengths? (3) Does it follow the rules, such as a budget or a ramp limit?
Worked example 1: rounding the right way. Zara solves 5.5b = 64. Step 1: 64 ÷ 5.5 = 11.636…, about 11.6. Step 2: interpret: 11 boards cover 11 × 5.5 = 60.5 inches, short of 64. Step 3: round up to 12 boards, which cover 66 inches, and trim 2 inches. Rounding to the nearest whole number is not always right; the story decides.
Worked example 2: estimate first. Omar checks the sample carpenter bill 29.12h + 45 = 248.84 from Lesson 1.04. Step 1: estimate with friendly numbers: 30h + 45 ≈ 250, so 30h ≈ 205 and h is a little under 7. Step 2: the exact answer is 7. Step 3: 7 is close to the estimate, so it is reasonable. If he had gotten 70 hours, the estimate would flag it.
Rules can change the plan. Suppose the shed floor were 36 inches above the ground. The guide says one run can rise at most 30 inches, and 36 > 30, so the ramp needs two runs, for example 18 inches each. Each run then needs 12 × 18 = 216 inches of length, with a landing between them.
Inequality answers need meaning too. b < 8.75 bags means 0 to 8 whole bags. c > 9.58 cars means at least 10 cars. Write the answer as a sentence a volunteer could act on.
Estimate first, then solve, then write a sentence that interprets the answer.
Write the three-question check next to each answer.
A sample shed floor is 42 inches above the ground. How many ramp runs are needed at a 30-inch maximum rise? If the runs are equal, how high is each and how long is each at 1:12?
A volunteer solves 2.5d + 40 = 15 for the days a barrel lasts and gets d = −10. What is the best response?
Choose one answer from this week's work. Write it as a sentence a garden volunteer could act on, with units.
Answers need meaning. Next we become error detectives and fix the most common equation mistakes.
Exit ticket: 6p + 15 = 100 gives p ≈ 14.2 packs of screws needed. How many packs should the crew buy? Explain.
Pacing: Do Now 5 min, reading 7, mini lesson 12, guided practice 11, exit ticket 5.
Accuracy: the 1:12 maximum (8.33%), the recommendation of a running slope of at most 7.5% and cross slope of at most 1.5% for exterior ramps (from a Board-sponsored study), the 30-inch rise per run, no limit on runs, landing rules and the note about manual wheelchair effort are from the Access Board guide. Board widths, floor heights and gravel amounts are sample data.
Likely misconceptions: always rounding to the nearest whole number; accepting negative lengths or days; ignoring the 30-inch rule.
Answer guide: 42 > 30, so 2 runs of 21 inches; each run 12 × 21 = 252 inches. Gravel: 7 bags is not enough; buy 8. Exit ticket: buy 15 packs, because 14 packs are short.
U.S. Access Board, Guide to the ADA Accessibility Standards, Chapter 4: Ramps and Curb Ramps · U.S. government work, public domain
The Access Board’s ramp chapter explains not only the rules but why they exist. The steepest running slope allowed is 1:12, about 8.33%. The guide recommends going gentler when possible, because a less steep ramp works for more people.
For outdoor ramps, the guide points to a study sponsored by the Board. It suggests designing for a running slope of at most 7.5% and a cross slope of at most 1.5%. A cross slope is the tilt from side to side. Designing a little under the limit leaves room for small building errors and uneven materials.
Each run can rise at most 30 inches. There is no limit on the number of runs. But the guide warns that long ramps with many runs are hard work for people using manual wheelchairs, and landings give rest stops without reducing the total effort.
Level landings are required at the top and bottom of each run. The slope along a run should stay the same from start to finish, because sudden changes can disrupt wheelchair travel. In other words, a ramp that fits the numbers on paper still has to work for the people who use it.
Source: U.S. Access Board, Guide to the ADA Accessibility Standards, Chapter 4: Ramps and Curb Ramps (access-board.gov)