cut a parallelogram and slide the piece to make a rectangle, and use that to find the area of any parallelogram with base times height.
Phase 2: Investigate
Do Now. A garden path is shaped like a slanted rectangle, called a parallelogram. Its bottom edge is 9 ft long, its slanted side is 5 ft, and it is 4 ft straight across from bottom to top.
Which two numbers do you think give the path's area?
The reading opens over the lesson; close it to come back to exactly where you were.
A parallelogram is a four-sided shape whose opposite sides are parallel, which means they never meet. Rectangles, squares and rhombuses are all special parallelograms. The base is any side we choose as the bottom. The height is the straight-across distance from the base to the opposite side, measured at a right angle (a square corner) to the base.
Cut and slide. Draw a parallelogram on grid paper. Cut straight up from one corner of the base, along the height, to cut off a right triangle. Slide that triangle to the other end. The pieces make a rectangle. Nothing was added or thrown away, so the area did not change.
The formula. The rectangle’s length is the parallelogram’s base, and its width is the parallelogram’s height. So the area of a parallelogram is A = b × h. The slanted side is not part of the formula.
Worked example 1: the garden path. Jada’s path has base 9 ft, slanted side 5 ft and height 4 ft. Step 1: choose the numbers: b = 9 and h = 4. Step 2: A = 9 × 4 = 36. Step 3: write the unit: 36 ft². Check: on grid paper, the cut-and-slide rectangle is 9 squares by 4 squares, which is 36 squares.
Worked example 2: a fraction base. Omar’s flower bed is a parallelogram with base 6 1/2 ft and height 4 ft. Step 1: write 6 1/2 as 13/2. Step 2: A = 13/2 × 4 = 52/2 = 26. Step 3: 26 ft². Check another way: 6 × 4 = 24 and 1/2 × 4 = 2, and 24 + 2 = 26.
Rhombuses too. A rhombus has four equal sides, and it is a parallelogram. A rhombus with sides 5 cm and height 4 cm has area 5 × 4 = 20 cm², not 5 × 5.
Work with a partner. Draw each shape on grid paper, mark the base and the height, and cut and slide if you need to.
Draw a sketch for each problem.
A parallelogram patio has base 12 1/2 ft and height 2 ft. Its area is square feet. (Write a whole number.)
A parallelogram has an area of 48 square feet and a height of 6 feet. How long is its base?
Draw two different parallelograms on grid paper that each have an area of 24 square units. Label the base and height of each.
A parallelogram is a rectangle in disguise. Next we discover that a triangle is half of a parallelogram.
Exit ticket: a parallelogram has base 8 ft, slanted side 5 ft and height 4 ft. Find its area and explain which number you left out and why.
Pacing: Do Now 4 min, reading 7, mini lesson 10, cutting and sliding in pairs 14, exit ticket 5.
Materials: 1-cm grid paper, scissors, rulers, a set square or the corner of an index card for checking right angles.
Accuracy: the NASA page lists rectangle, trapezoid, triangle and ellipse formulas; it does not mention parallelograms. The parallelogram is our own step from its rectangle formula. Ellipses and circles are beyond grade 6 area, so we do not use them.
Likely misconceptions: multiplying base by the slanted side; thinking height must be a side of the shape; believing a rhombus’s area is side squared.
Supports: pre-drawn parallelograms with the height dashed. Stretch: does the cut work if the height falls outside the base? (Yes, with more than one cut.)
Answer guide: two parallelograms with area 24: for example b = 6, h = 4 and b = 8, h = 3. Exit ticket: 8 × 4 = 32 ft²; the 5-ft slanted side is left out because cutting and sliding makes a rectangle 8 by 4.
NASA Glenn Research Center, Beginner's Guide to Aeronautics: Area · U.S. government work, public domain
NASA’s Glenn Research Center has a Beginner’s Guide to Aeronautics, the science of flight. One page is about area.
The page shows the shapes of airplane wings and rocket fins as seen from the side, looking straight onto the fin. This flat outline is called a planform. Wings come in many planforms: rectangles, triangles, trapezoids and even ovals.
Why does the shape matter? To figure out how much lift (the upward push that holds a plane up) and drag (the push of air that slows it) a wing makes, an engineer must be able to find its area. The page says this skill is taught in middle school and used every day by design engineers.
NASA explains that area is the two-dimensional amount of space an object covers. It is measured along the surface and has units of length squared, such as square feet or square centimeters. The first formula on the page is for a rectangle: the area equals the height times the base. Other shapes on the page have their own formulas, and we will build those from the rectangle one at a time.
Source: NASA Glenn Research Center, Beginner's Guide to Aeronautics: Area (grc.nasa.gov)